Wodaplug EOC Indoor Slave with 300Mbs WiFi speed router - EOC1121R4WL-R410, 600Mbps, 4*LAN, 2*F, WEB Management, VLAN, IGMP, QoS ...
Jednotka EoC slave s WiFi je určena pro koncové uľivatele, kteří ji chtějí vyuľít i jako WiFi router s NAT a nebo Brdige, spolupracuje s EoC master jednotkou na navázání spojení a přenosu sítě Ethernet přes koaxiální rozvod. Z mixed signálu opět převede data na výstup Ethernet+WiFI a signál TV na výstup TV. Vlastní IP adresa. Nyní nová verze s dvěma anténami pro lepší WiFi pokrytí ! Pro správnou funkci je potřeba nový firmware pro Master jednotku viz návody.
New MTK based WiFi slave with 2 antennas and 300Mbps WiFi speed available - EOC1121R4WL-R410 !!! This new Realtek based version can offer same features, but need to update SW on your EOC master, can accept same template configuration. WEB based management for this new EOC WiFi slave is differnt, read new users guide!
EOC1121R4WL-R410 modem is the EOC slave based on HomePlug AV solution for Ethernet access over coax. It works together with EOC master which is based on HomePlug AV solution as well to construct a two-layer Ethernet data transmission channel on CATV coax cable, provide the Ethernet access service based on the existing coax cable networking.
EOC1121R4WL-R410 series is based on the Mstar chipset solution (510CE chip)，with high anti jamming capability OFDM technology. The 7.5-65MHz low frequency band is used for EOC signals. Built in high isolation filter as CATV RF and EOC signal mixer, the EOC signal and CATV signal in 87Mhz~1Ghz can run on one cable without interference. The PHY Layer speed is 600Mbps,the MAC Layer throughput is up to 320Mpbs.
EOC1121R4WL-R410 series WIFI is based on the MTK chipset solution. It meets 802.11 b/g/n technical standards. It has two external antenna, and can support 2.4GHz wireless signal. It has the characteristics of strong penetrating power and wide coverage. It can provide users with more efficient data transmission security.
Based on MSTAR+MTK chipsets solution of HomePlug AV and 11n WiFi technology
Work at low frequency between 7.5MHz~65MHz without influence on CATV service
Physical layer speed is 600Mbps and Max MAC layer throughout is 320Mbps
Support data encryption for both uplink and downlink
Support 4*10/100Mbps Ethernet ports auto-negotiation function
Support slave(CPE) isolation
Support VLAN configuration based on slave’s Ethernet ports and 802.1q
Support bandwidth(speed) limitation for both uplink and downlink
Support QoS configuration based on slave port or VLAN
Support broadcast storm control
Support data packages count
Automatically distribute configurations to newly connected slaves, available to use as soon as correctly connected and power on
Support WEB,CLI and SNMP management
Support on-line upgrading
default IP for management : http://192.168.1.1
For the software, there is no difference between the old and new slave. Please read new users guide. The full access and complete setting in Web could be realized via the admin access.
The new version wifi slave is more flexible in the application than before. It can controls the STB1 and STB2 ports which used as the Ethernet ports to setting the VLAN, rate-limiting, configuration,etc.
The LAN1 and LAN2 have the router feature which support the PPPoE. Moreover, The two mode can work at the same time.
- Item Specification - Model Number - EOC1121R4WL-R
- Chipsets Mstar(C510E), MTK 11n
- Protocol EOC standard : HomePlug AV/ IEEE P1901(Draft); Etherent protocol > IEEE 802.1Q, IEEE 802.1p, IEEE 802.3, IEEE 802.3u, IEEE 802.3x,HTTP, SNMP, TELNET
- Phisycal Speed 600Mbps
- Modulation Bandwidth 7.5 MHz~65 MHz
- Modulation Technology OFDM-2690-carriers,4096/1024/256/64/16/8-QAM, QPSK, BPSK, ROBO
- Max. Slave number 256
- Encryption mode 128-bit AES encrypted
- VLAN Support max. 16 VLANs
- Limitation of port speed Support minimum 64Kbps granularity
- QoS Support VLAN priority
- Working mode CSMA/CA
- Multicast support Support IGMP manage Multicast diagram
- Management mode Support SNMP, WEB, CLI multi-managed mode
- Ethernet Interface 4*10/100M Ports
- Coax. Cable Interface 1*Female Connector, IP signal output
- Ethernet Network connection indicator
- Power Power connection indicator
- Data Cable connection indicator
- Impedance 75Ohm
- Transmit Power 0±3dBm
- Reflection loss >16dB
- Insertion loss less than 1dB
- Receiving sensitivity -65dB
- Working Temperature 0℃~50℃
- Storage Temperature -40℃~80℃
- Working Humidity 10%~90%, non-condensation
- Storage Humidity 5%~90%, non-condensation
- Environmental standards RoHS
- Product Size 160*120*28.5mm
- Product Weight N.W.: 0.5kg G.W.: 0.52kg
- WiFi Specification
- Operating Mode > Router or Bridge
- Frequency Range : 2,412-2,472GHz
- Transmitting Speed : 11n [135Mbps]:standard + 802.11b/g standard /auto-negotiation/
- Operating channels qty : 13
- Spread Spectrum : DSSS, CCK and OFDM
- Coding BPSK, QPSK, 16QAM and 64QAM
- RF Power : 802.11b: 16.5±1dBm , 802.11g: 13±1dBm @ 54 Mbps; 14±1dBm @ 48 Mbps; 15±1dBm @ 6 ~ 36 Mbps ; 802.11n: 13±1dBm @ 54 Mbps; 14±1dBm @ 48 Mbps; 15±1dBm @ 6 ~ 36 Mbps
- antenna : 4dBi (fixed)
- RF Receiving Sensitivity : 802.11b: -82dBm @ 1 Mbps; -80dBm @ 2 Mbps; -78dBm @ 5.5 Mbps; -76dBm @ 11 Mbps 802.11g: -82dBm @ 6 Mbps; -81dBm @ 9 Mbps; -79dBm @ 12 Mbps; -77dBm @ 18 Mbps; -74dBm @ 24 Mbps; -70dBm @ 36 Mbps; -66dBm @ 48 Mbps; -65dBm @ 54 Mbps 802.11n: -65dBm @ 65 MbpsHT40; -61dBm @ 135 MbpsHT40
- Encryption Mode 802.11i Security: WEP-64/128, TKIP(WPA-PSK) and AES(WPA2-PSK)